See how DigiSpec reads a legacy document
Sample documents written for testing. On the left, the document as written. On the right, what DigiSpec records.
Three suppliers' documents, three layouts
Specification A · a table
Magnesium content | EDTA titration | 4.0% – 5.0% w/w as Mg
Specification B · numbered clauses
“…not less than 4.0 per cent and not more than 5.0 per cent weight-for-weight, calculated on the dried basis.”
Specification C · running text
“…must fall within the range of 4.0 to 5.0 percent weight-for-weight calculated on the anhydrous basis.”
What DigiSpec records
Magnesium contentQuality
4.0 – 5.0 % w/w
Found in all three documents. Same limit, three ways of writing it. Each value keeps the page it came from.
The document says
Microcrystalline cellulose specification · test limits
pH (2% slurry) | Per monograph | Per Ph.Eur. 01/2008:0316 — no numeric limit transcribed
Same document
Loss on drying | USP <731> 105°C, 1 hr | NMT 5.0%
What DigiSpec records
pHQuality
No limit in this document
The document points to the pharmacopoeia instead of giving a number. DigiSpec records that, and never fills in a number that isn't on the page.
Loss on dryingQuality
Not more than 5.0 %
One product specification, two pages
Page 1
Shelf Life: 36 MONTHS
Page 3
“an 18-month shelf life is supported at the current time”
What DigiSpec records
Shelf lifeQuality
36 months or 18 months
The document disagrees with itself. Both values are shown to you with their pages. Nothing goes in until you choose.
The document says
Magnesium stearate specification · test limits
Loss on Drying (105°C, 2 hr) | USP <731> | NMT 6.0%
Same document · safety section
OEL (inhalable dust) | 10 mg/m³ TWA | Company internal limit
What DigiSpec records
Loss on dryingQuality
Not more than 6.0 % (105 °C, 2 hours)
Occupational exposure limitSafety
10 mg/m³, time-weighted average
Safety limits are kept apart from the limits a batch is tested against.
Test with your own documents
By invitation. Ask us for access.